Installation video for Greenfilm's G-Cling Custom Pre-cut automotive window tint. <br /> <br />Before Application: <br />Be sure all windows are clean and free of dust/debris. You can clean the window with the solution and squeegee. <br /> <br />Step 1: Roll window down 3 inches. Place dry film onto the window. Spray generously to allow any dirt to drip off the film. <br /> <br />Step 2: Adjust film leaving 3/8 inch from the top of the film to the top of the window. <br />Tip: Lift edges of the film and apply the solution to adjust smoothly. <br /> <br />Step 3: Spray then squeegee from the center to the top, then from the center to all edges making sure all bubbles are removed. <br />Tip; If the film does not reach the edge of the window, you can gently stretch the film to fill the gap. <br />If any bubbles remain, you can spray and squeegee again. <br />Tip: Be sure to use the squeegee on wet film to prevent damage. <br /> <br />Step 4: Roll up the window. Spray the solution on and under the film. <br /> <br />Step 5: Squeegee the bottom half of the window. <br />Tip: Use the small yellow squeegee to gently insert the film into the side of the window. <br /> <br />Step 6: Use the gasket push stick with the squeegee to push the film into the window seal. <br />Then use the yellow squeegee to remove any remaining bubbles. <br /> <br />Step 7: Spray the film and squeegee again to ensure all edges are flat and all bubbles are removed. <br />Tip Use tip of the large squeegee to ensure the film is inserted into the edges of the window. <br /> <br />Installation is done! Do not roll windows down or use the suction cup for 48 hours. <br /> <br />For more information, please Visit Our Website: <br />https://www.greenfilmusa.com/ <br /> <br />Or Email Us at <br />info@greenfilmusa.com <br /> <br />Call Us: <br />(972) 247-1176
